Circuit Applied Technology: Reverse Engineering Quote Form

Printed Circuit Board Specialists Since 1965

Reverse Engineering Quote

Please complete the following form to obtain a CAT Reverse Engineering Quote.
If you have more than one Circuit Board to be quoted please complete one form per Circuit Board.

If your CAT Reverse Engineering Quote is for you personally and not a company, please enter
your information in the boxes for you where company information is requested.

Please note you will be required to complete the form found here if you accept our quote.

If you can furnish digital pictures of both sides of the board in question it will allow us to provide you with a firm quote.
Please send to our email located here.

Your Contact Information:
(All information provided will be kept strictly confidential. We do not share or sell any information provided herein)

Who will be responsible for payment?

Your Company
Individual Named Herein

Enter appropriate information for responsible party:

Your Name:

Your Company's Name:

Company / Your Street Address:

Address 2nd Line:

City:

State / Province:

Zip / Postal Code:

Company / Your Tel. No. with Area Code:
Your Ext. No.:

Your Email Address:

Circuit Board Information:

Circuit Board Identifier:

This helps to identify the job in future correspondence

Max Board Size
(X:Y max dimensions in inches):
Example: 12.375 X 4.650
This specifies the major dimensions of the board in the X axis and the Y axis

Component Usage (check all that apply):
This tells us if components are mounted on both sides and whether the components
are through hole and/or surface mount

Thru-hole
SMT
One Side
Both Sides

No. of Board Layers:
This lets us know the additional complexity of the proposed job.
Please refer to this paragraph for additional information.

Internal Layers:

Power and Ground
Generally, most multilayer boards will have a power and ground layer.
Check this if your board has internal and separate Power and Ground layers.

Signal
Do any internal layers contain signal traces?

Special Requirements:

External Ground Plane (complete coverage, one side, no signal traces)
Some boards have external ground planes with no signals routed on it. This is 100% coverage.

External Shielding (selective coverage of one or both sides):
Shielding is distinct from an external ground plane in that it will not completely cover the
board surface, as noted above, and will have signal traces embedded within the shielding.

Component Side, % of layer
Solder Side, % of layer

Total Component Leads (Ex.: a resistor has 2 leads):
We cannot provide you a quote without this

Date Design MUST be ready for Fabrication (mm-dd-yy):

Customer Comments:
In the event we missed a detail important to your design, please indicate that below:

Please specify how you want your quote to be sent to you:

Email address as entered above
A different email address:

Thank you for submitting your Reverse Engineering request for quote!

CAT Home

Your Name:
Your Company's Name:
Company / Your Street Address:
Address 2nd Line:
City:
State / Province:
Zip / Postal Code:
Company / Your Tel. No. with Area Code:	Your Ext. No.:
Your Email Address:

Circuit Board Identifier:	This helps to identify the job in future correspondence
Max Board Size (X:Y max dimensions in inches):	Example: 12.375 X 4.650 This specifies the major dimensions of the board in the X axis and the Y axis

Total Component Leads (Ex.: a resistor has 2 leads): We cannot provide you a quote without this
Date Design MUST be ready for Fabrication (mm-dd-yy):